Avoid Car Accidents By Installing High Quality Tail Lights

As we know, one of the important way of ensuring safety and security while you are driving is the use of high quality tail lights.
Continue reading

How to Install Ford F150 Tail lights

Like all vehicles on the street, the Ford F-150 has a tail light placed on each side of the rear of the car. If your F-150 has a broken tail light lens you may}pay a dealer to change it, or you can install your tail light yourself about few minutes.

Required Tools: 3/8 drive ratchet; 8mm socket.

Step one: lower the steel gate and locate two 8mm blots. Remove those two 8mm bolts in order to free the led tail light.

Step two: While moving the tail light, you should pull it outward away from vehicle. Go ahead and disconnect the light harness.

Step three: get a new Ford tail light, and then connect both light harness to the start harness. Next, install light socket.

Step four: properly set the tail light and install the two 8mm blots.

How to Install Toyota Tail Lights

Installation of Toyota Tail Lights

Required Tools: 3/8 drive ratcht; 10mm socket; panel popper.

Step one: remove your trunk carpet.

Step two: remove 2 plastic clips securing the plastic truck and take plastic trim away from your car. Now you car remove 3 plastic clips securing the carpet truck liner.

Step three: pull trunk liner aside and use panel popper to remove three 10mm nuts. Then disconnect the tail light harness.

Step four: install a new tail light and tighten it with three 10mm nuts.

Step five: connect tail light harness. Then reinstall the carpet liner and three clips.

Step six: check your tail lights.

Tint Your TYC Tail Lights

If you are looking at tinting up your TYC tail lights, then there are several things that you will need to accomplish this. The first things that you will need are the lights. The best lights that you can work with are the TYC alteeza tail lights that are specific to your vehicle. You will also require a VHT night shade, a green tape used by painters, a knife, platinum garde Turtle Wax and grit remover and Mothers Polishing Ball.

You need to tape up the whole TYC alteeza tail light using the painters tape. On each of the sides that are fixated on the trunk. You should also overlap the painters tape so that the whole of the tail light is covered with minimal overlapping. Using your knife, you should also cut out the clear part of your TYC alteeza light using minimal force. This ensures that you do get great benefits that are seen with this form of lighting.

Next, set up a table that you will use for painting of your light. With this done, take up your night shade and start painting using the VHT nightshade. You should start with the top and inside of the light. While doing this, ensure that you do not overspray the night shade as you still want to be visible at night to other drivers. There should be about 7 stages of this that should be done for you to recognize significant difference.

With the painting done, give about 20 minutes per coat so that this dries off. Rub off with wet sand which comes at 2000 grit. This ensures that your night sgade isheld down well and does not easily peel off. When you are satisfied with the TYC alteeza tail lights tinting, just apply a layer of clear over them and then use a polisher. The best is a 1000-1500 3M grit fine compound. With this done, buff it up with Mothers Polishing ball and then Platnium Turtle Wax co come to a great shine.